CC1 - REMOVAL OF BRUSH DECK FROM ROBOT
How to remove the Brush Deck from under the Robot
CC1 - CHANGING OUT THE DRAIN VALVE
How to diagnose a broken drain valve
CC1 - INSTALLING ANTI TANGLE RETRO KIT FOR SPINDLES
Depending on the venue being cleaned, buildup can occur under the spindles for the brushes. Retro kits are available to help prevent this buildup during use.
CC1 - BRUSH ENCODER ERROR
Getting a brush encoder error when having the Robot clean
CC1 - SCREEN REPLACEMENT
How to replace screen display of robot
CC1 - CLEANING THE BRUSH DECK
Recommended way of cleaning the brush deck under the CC1 Robot
CC1 - SELF INSPECTION FAILED LIDAR TOF
What to do check when encountering a TOF self inspection error
CC3 - BATTERY WARNING REQUIRING A FULL CHARGE
Getting a warning on the Robot screen requring a full charge
CC1 - NO MAGNETIC ERROR SELF INSEPCTING
Getting a No Magnetic error. How to check status of sensor and bypass if needed
CC3 - TURN OFF BACKFILLING OF DIRTY TANK TO CLEAN
How to turn on/off water filteration of dirty tank into the clean tank
CC1 - CURRENT MAP AND TASK MAPS HAVE UNSATISFACTORY ELEVATOR OR SWITCHING POINT
When sending the Robot to clean, it presents this error saying there are unsatisfactory points
CC1 - SCREEN NOT ROTATING PROPERLY
When lifting the screen of the Robot, the display does not rotate as it should
CC1 - ADJUST DOCKING DISTANCE TO WORKSTATION
Adjust the distance the Robot places itself in front of workstation for docking
CC1 - FRONT SHELL REMOVAL
How to remove front shell of Robot
CC1- TASK ERRORS UPON START UP - INCORRECT MAP
Troubleshooting of clean task errors, upon start up. Related to the map selection and or task settings.
CC1 - CLEANING MOTOR (ENOCDEERROR)
If you encounter this error you will need to inspect the brushes, and ensure they are properly installed and free of debris and entanglements.
CC1 - DIRTY WATER TANK SENSOR LEVEL ISSUES
If the dirty water tank sensor is not accurately displaying water levels when the tank is empty, it is likely due to dirt or residue buildup on the sensor. Follow these steps to resolve the issue.
CC1 - ADJUSTING THE OPERATIONAL MOVEMENT SPEEDS IN SETTINGS
How to adjust the CC1's operational movement Speed settins in the settings menu.
CC1 - BOT NOT DROPPING WATER
Robot is not dropping water when cleaning
CC1 - REPLACING ELECTRODES
How to replace electrodes on back of BoT
CC1 - TOP COVER AND REAR SHELL REMOVAL
How to remove the top cover and rear shell of BoT
CC1 - MANUAL DRAINAGE OF DIRTY TANK AND CLEAN WATER REFILL
If the workstation is down or if you do not have a workstation installed, you will need to manully drain the dirty tank, and refill the unit with clean water.
CC1 - CLEANING MOTOR ERROR - EDGESWIPEERROR- SIDE BRUSHSTALL
Getting a Cleaning Motor Error - EdgeSwipeError - Side Brush Stall and pressing restore does not fix the issue
HOLA - DEACTIVATE THE BUMP SENSOR SWITCH TO BYPASS ERROR
How to deativate the anti-collision bump sensor strip in the BoT's menu if you encounter a start up error due to senor wire damage.
CC1 - U PHASE AND V PHASE HARDWARE OVERCURRENT ERRORS
Getting a U phase or V phase overcurrent error can be caused by the way the brushes were installed, or entanglements. First check placement of brushes, if those look good you will next need to check for entanglements in the brushes or the spindles.